TYTAN Roof & Flashing Sealant provides a durable seal when installing and repairing all roofs. It resists weathering, UV radiation, vibration, moisture, rain, snow and extreme temperature fluctuations. It uses TYTAN’s non-slump, non-shrink technology so you can be confident it will maintain the shape and size you intended. It will allow movement to occur with good recovery while maintaining strong adhesion. It may be used on most roofing and construction materials including: metal, asphalt, rubber, ceramic tile, wood, concrete, tar paper, most plastics. With TYTAN Roof & Flashing Sealant you can Build with Confidence!
Surface area must be fully cured, dry, clean, and free of dust, oil, grease, debris, contaminants, or release agents that could interfere with proper adhesion. It is recommended to perform and evaluate preliminary adhesion and compatibility tests before use. For proper surface preparation techniques visit the “Try TYTAN” section of TYTAN.com.
Cut nozzle at 45° to desired bead size, insert in caulking gun and apply to desired area. Tool bead with moistened cloth and wipe off excess before it cures. For best results, tool immediately after applying for best adhesion and smooth finish before skinning occurs. Please see the technical specification for acceptable application temperatures and other technical information.
Remove Sealant off gun and all tools before it cures. Use TYTAN Foam Cleaner, turpentine, or extraction naphtha and let dry to prevent any damage. Cured sealant can be removed with sharp tools, using caution.
Polyurethane typically takes more time to cure, but the curing time depends on the moisture in the air. Since it provides a more solid seal, polyurethane sealants are more difficult to apply compared to more flexible sealants. Polyurethane cannot be applied in low temperatures but it will resist cracking due to extremely low temperatures after it is cured.
Keep out of the reach of children. Wear safety glasses with side shields. Direct contact with eyes may cause slight to moderate irritation. In case of eye contact, flush thoroughly with water for at least 15 minutes. Seek immediate medical attention. In case of skin contact, wash affected areas with soap and water. If irritation persists seek medical attention. Move to fresh air if inhalation causes discomfort. Refer to MSDS for further information.
If you are not happy with the products performance please call 855-44-TYTAN or contact us at TYTAN.com.