TYTAN PU40 FC+ Sealant is a polyurethane sealant designed for the most extreme or general construction applications. It resists UV radiation, weathering, climate changes, rain, snow, and moisture. It uses TYTAN’s non-slump, non-shrink technology so you can be confident it will maintain its shape, size, and seal. It is flexible enough to allow movements caused by construction and climate changes with good recovery while maintaining strong adhesion. It may be used on most construction materials including: metal, asphalt, rubber, ceramic tile, wood, concrete, tar paper, and most plastics. With TYTAN PU40 FC+ Sealantyou can Build with Confidence!
Surface area must be fully cured, dry, clean, and free of dust, oil, grease, debris, contaminants, or release agents that could interfere with proper adhesion. It is recommended to perform and evaluate preliminary adhesion and compatibility tests before use. For more information visit the “Try TYTAN” section of TYTAN.com.
Cut nozzle at 45° to desired bead size, insert in caulking gun and apply to desired area. Tool bead with moistened cloth and wipe off excess before it cures. For best results, tool immediately after applying for best adhesion and smooth finish before skinning occurs. Please see the technical specification for acceptable application temperatures and other technical information.
Polyurethane sealants are not recommended for continuous water immersion use, exterior below grade use, or high traffic areas. It should not be used on materials that bleed oils or plasticizers, or in totally confined spaces where it is not exposed to atmospheric moisture. It may discolor natural stones, marble or granite, brass, copper or other sensitive materials. Do not apply to damp or contaminated surfaces.
Keep out of the reach of children. Wear safety glasses with side shields. Direct contact with eyes may cause slight to moderate irritation. In case of eye contact, flush thoroughly with water for at least 15 minutes. Seek immediate medical attention. In case of skin contact, wash affected areas with soap and water. If irritation persists seek medical attention. Move to fresh air if inhalation causes discomfort. Refer to MSDS for further information.
If you are not happy with the products performance please call 855-44-TYTAN or contact us at TYTAN.com.