TYTAN Premium Seal provides an innovative, versatile formula that is a handyman must-have. It may be used on interior & exterior applications and is paintable. This innovative formula provides the structural advantages of a silicone, with the application benefits of an acrylic. It is a low odor anti-slump and anti-shrink formula that won’t break down in extreme weather. It provides a strong seal and bond to most construction materials so you can be confident that it will seal every project, every time. With TYTAN Premium Seal you can Build with Confidence!
Surface area must be fully cured, dry, clean, and free of dust, oil, grease, debris, contaminants, or release agents that could interfere with proper adhesion. It is recommended to perform and evaluate preliminary adhesion and compatibility tests before use. For proper surface preparation techniques visit the “Try TYTAN” section of TYTAN.com.
Cut nozzle at 45° to desired bead size, insert in caulking gun and apply to desired area. Tool bead with moistened cloth and wipe off excess before it cures. For best results, tool immediately after applying for best adhesion and smooth finish before skinning occurs. Please see the technical specification for acceptable application temperatures and other technical information.
Do not apply over damp or contaminated surfaces. It is not designed to support loads from pedestrian or vehicular traffic in floor or ceiling applications. After application, protect against rain for at least 6 hours. It is not suitable for bituminous substrates, based on natural rubber, chloroprene or other materials that might bleed oils, plasticizers or solvents. It should not be used on metallic surfaces, or copper. It is not recommended for continuous immersion in water.
Remove sealant with soap and water from gun and all tools before it cures and let dry to prevent any damage. Cured sealant can be removed with soap and water or with sharp tools, using caution.
Keep out of the reach of children. Wear safety glasses with side shields. Direct contact with eyes may cause slight to moderate irritation. In case of eye contact, flush thoroughly with water for at least 15 minutes. Seek immediate medical attention. In case of skin contact, wash affected areas with soap and water. If irritation persists seek medical attention. Move to fresh air if inhalation causes discomfort. Refer to MSDS for further information.
If you are not happy with the products performance please call 855-44-TYTAN or contact us at TYTAN.com.