TYTAN Fix ‘n Seal ES is a premium, innovative, fast-acting adhesive that adheres lightweight materials to vertical surfaces within seconds. Fix ‘n Seal ES will adere lightweight materials within 10 seconds and produces a strong hold on materials up to 500 lbs after full cure. It is not affected by normal vibrations, weather, UV radiation, extreme climate changes, or extreme temperatures. It may be used on Interior & Exterior projects and even cures on wet surfaces. The unique formula allows for thousands of uses and it cures clear to hide any messes. Its solvent free formula protects you and the enviorment from unpleasant chemicals. With TYTAN Fix ‘n Seal ES Instant Adhesive you can Build with Confidence!
Always read all operating, application, and safety instructions before using any products from Selena Group. Use in conformance with all local, state, and federal regulations and safety requirements. Read all product directions and safety information before use.
Surface area must be fully cured, dry, clean, and free of dust, oil, grease, debris, contaminants, or release agents that could interfere with proper adhesion. It is recommended to perform and evaluate preliminary adhesion and compatibility tests before use. For proper surface preparation techniques visit the “Try TYTAN” section of TYTAN.com.
Cut nozzle at 45° to desired bead size, insert in caulking gun and apply in serpentine bead to desired area. Press the substrate firmly against the bead and hold. The substrate must be attached within 5 minutes after applying the bead. Use mechanical fasteners to secure the substrate. Please see the technical specification for acceptable application temperatures and other technical information.
Hybrid Adhesives are the most technologically advanced adhesives on the market. Their unique curing process makes them environmentally friendly, solvent and isocyanate free. They are extremely strong and adhere to more substrates than any other technology. It can cure in the most extreme conditions, including extreme temperatures. Fix ‘n Seal ES provides extremely fast adhesion. It can adhere lightweight objects to vertical substrates after only seconds of applying pressure.
Hybrid Adhesives should not be exposed to continuous water submersion. It should be applied in small joints of less than ¼”. It does not react well to bitumen, house wrap, polyethylene, polypropylene, or polyamide.
Remove Adhesive off gun and all tools before it cures. Use typical solvents such as Mineral Spirits or lacquer thinner and let dry to prevent any damage. Cured sealant can be removed with sharp tools, using caution.
Keep out of the reach of children. Wear safety glasses with side shields. Direct contact with eyes may cause slight to moderate irritation. In case of eye contact, flush thoroughly with water for at least 15 minutes. Seek immediate medical attention. In case of skin contact, wash affected areas with soap and water. If irritation persists seek medical attention. Move to fresh air if inhalation causes discomfort. Refer to MSDS for further information.
If you are not happy with the products performance please call 855-44-TYTAN or contact us at TYTAN.com.